ref: b22cc88f1a3d9aa53fbd659e45f188497731b687
dir: /src/bit-rot/sys/audioio.h/
#ifndef HAVE_SUN_AUDIO
/*
* SoX bit-rot detection file, obtained from: Solaris 9 /usr/include/sys
*/
#if defined __GNUC__
#pragma GCC system_header
#endif
/*
* Copyright (c) 1995-2001 by Sun Microsystems, Inc.
* All rights reserved.
*/
#ifndef _SYS_AUDIOIO_H
#define _SYS_AUDIOIO_H
#pragma ident "@(#)audioio.h 1.30 01/01/10 SMI"
#include <sys/types.h>
#if 0
#include <sys/types32.h>
#include <sys/time.h>
#include <sys/ioccom.h>
#else
#define ushort_t unsigned short
#define uint_t unsigned int
#define uchar_t unsigned char
struct timeval32
{
unsigned tv_sec;
unsigned tv_usec;
};
#endif
/*
* These are the ioctl calls for all Solaris audio devices, including
* the x86 and SPARCstation audio devices.
*
* You are encouraged to design your code in a modular fashion so that
* future changes to the interface can be incorporated with little
* trouble.
*/
#ifdef __cplusplus
extern "C" {
#endif
/*
* This structure contains state information for audio device IO streams.
*/
struct audio_prinfo {
/*
* The following values describe the audio data encoding.
*/
uint_t sample_rate; /* samples per second */
uint_t channels; /* number of interleaved channels */
uint_t precision; /* bit-width of each sample */
uint_t encoding; /* data encoding method */
/*
* The following values control audio device configuration
*/
uint_t gain; /* gain level: 0 - 255 */
uint_t port; /* selected I/O port (see below) */
uint_t avail_ports; /* available I/O ports (see below) */
uint_t mod_ports; /* I/O ports that are modifiable (see below) */
uint_t _xxx; /* Reserved for future use */
uint_t buffer_size; /* I/O buffer size */
/*
* The following values describe driver state
*/
uint_t samples; /* number of samples converted */
uint_t eof; /* End Of File counter (play only) */
uchar_t pause; /* non-zero for pause, zero to resume */
uchar_t error; /* non-zero if overflow/underflow */
uchar_t waiting; /* non-zero if a process wants access */
uchar_t balance; /* stereo channel balance */
ushort_t minordev;
/*
* The following values are read-only state flags
*/
uchar_t open; /* non-zero if open access permitted */
uchar_t active; /* non-zero if I/O is active */
};
typedef struct audio_prinfo audio_prinfo_t;
/*
* This structure describes the current state of the audio device.
*/
struct audio_info {
/*
* Per-stream information
*/
audio_prinfo_t play; /* output status information */
audio_prinfo_t record; /* input status information */
/*
* Per-unit/channel information
*/
uint_t monitor_gain; /* input to output mix: 0 - 255 */
uchar_t output_muted; /* non-zero if output is muted */
uchar_t ref_cnt; /* driver reference count, read only */
uchar_t _xxx[2]; /* Reserved for future use */
uint_t hw_features; /* hardware features this driver supports */
uint_t sw_features; /* supported SW features */
uint_t sw_features_enabled; /* supported SW feat. enabled */
};
typedef struct audio_info audio_info_t;
/*
* Audio encoding types
*/
#define AUDIO_ENCODING_NONE (0) /* no encoding assigned */
#define AUDIO_ENCODING_ULAW (1) /* u-law encoding */
#define AUDIO_ENCODING_ALAW (2) /* A-law encoding */
#define AUDIO_ENCODING_LINEAR (3) /* Signed Linear PCM encoding */
#define AUDIO_ENCODING_DVI (104) /* DVI ADPCM */
#define AUDIO_ENCODING_LINEAR8 (105) /* 8 bit UNSIGNED */
/*
* These ranges apply to record, play, and monitor gain values
*/
#define AUDIO_MIN_GAIN (0) /* minimum gain value */
#define AUDIO_MAX_GAIN (255) /* maximum gain value */
#define AUDIO_MID_GAIN (AUDIO_MAX_GAIN / 2)
/*
* These values apply to the balance field to adjust channel gain values
*/
#define AUDIO_LEFT_BALANCE (0) /* left channel only */
#define AUDIO_MID_BALANCE (32) /* equal left/right channel */
#define AUDIO_RIGHT_BALANCE (64) /* right channel only */
#define AUDIO_BALANCE_SHIFT (3)
/*
* Generic minimum/maximum limits for number of channels, both modes
*/
#define AUDIO_CHANNELS_MONO (1)
#define AUDIO_CHANNELS_STEREO (2)
#define AUDIO_MIN_PLAY_CHANNELS (AUDIO_CHANNELS_MONO)
#define AUDIO_MAX_PLAY_CHANNELS (AUDIO_CHANNELS_STEREO)
#define AUDIO_MIN_REC_CHANNELS (AUDIO_CHANNELS_MONO)
#define AUDIO_MAX_REC_CHANNELS (AUDIO_CHANNELS_STEREO)
/*
* Generic minimum/maximum limits for sample precision
*/
#define AUDIO_PRECISION_8 (8)
#define AUDIO_PRECISION_16 (16)
#define AUDIO_MIN_PLAY_PRECISION (8)
#define AUDIO_MAX_PLAY_PRECISION (32)
#define AUDIO_MIN_REC_PRECISION (8)
#define AUDIO_MAX_REC_PRECISION (32)
/*
* Define some convenient names for typical audio ports
*/
#define AUDIO_NONE 0x00 /* all ports off */
/*
* output ports (several may be enabled simultaneously)
*/
#define AUDIO_SPEAKER 0x01 /* output to built-in speaker */
#define AUDIO_HEADPHONE 0x02 /* output to headphone jack */
#define AUDIO_LINE_OUT 0x04 /* output to line out */
#define AUDIO_SPDIF_OUT 0x08 /* output to SPDIF port */
#define AUDIO_AUX1_OUT 0x10 /* output to aux1 out */
#define AUDIO_AUX2_OUT 0x20 /* output to aux2 out */
/*
* input ports (usually only one at a time)
*/
#define AUDIO_MICROPHONE 0x01 /* input from microphone */
#define AUDIO_LINE_IN 0x02 /* input from line in */
#define AUDIO_CD 0x04 /* input from on-board CD inputs */
#define AUDIO_INTERNAL_CD_IN AUDIO_CD /* input from internal CDROM */
#define AUDIO_SPDIF_IN 0x08 /* input from SPDIF port */
#define AUDIO_AUX1_IN 0x10 /* input from aux1 in */
#define AUDIO_AUX2_IN 0x20 /* input from aux2 in */
#define AUDIO_CODEC_LOOPB_IN 0x40 /* input from Codec internal loopback */
#define AUDIO_SUNVTS 0x80 /* SunVTS input setting-internal LB */
/*
* Define the hw_features
*/
#define AUDIO_HWFEATURE_DUPLEX 0x00000001u /* simult. play & rec support */
#define AUDIO_HWFEATURE_MSCODEC 0x00000002u /* multi-stream Codec */
#define AUDIO_HWFEATURE_IN2OUT 0x00000004u /* input to output loopback */
#define AUDIO_HWFEATURE_PLAY 0x00000008u /* device supports play */
#define AUDIO_HWFEATURE_RECORD 0x00000010u /* device supports record */
/*
* Define the sw_features
*/
#define AUDIO_SWFEATURE_MIXER 0x00000001u /* audio mixer audio pers mod */
/*
* This macro initializes an audio_info structure to 'harmless' values.
* Note that (~0) might not be a harmless value for a flag that was
* a signed int.
*/
#define AUDIO_INITINFO(i) { \
uint_t *__x__; \
for (__x__ = (uint_t *)(i); \
(char *)__x__ < (((char *)(i)) + sizeof (audio_info_t)); \
*__x__++ = ~0); \
}
/*
* Parameter for the AUDIO_GETDEV ioctl to determine current
* audio devices.
*/
#define MAX_AUDIO_DEV_LEN (16)
struct audio_device {
char name[MAX_AUDIO_DEV_LEN];
char version[MAX_AUDIO_DEV_LEN];
char config[MAX_AUDIO_DEV_LEN];
};
typedef struct audio_device audio_device_t;
/*
* Ioctl calls for the audio device.
*/
/*
* AUDIO_GETINFO retrieves the current state of the audio device.
*
* AUDIO_SETINFO copies all fields of the audio_info structure whose
* values are not set to the initialized value (-1) to the device state.
* It performs an implicit AUDIO_GETINFO to return the new state of the
* device. Note that the record.samples and play.samples fields are set
* to the last value before the AUDIO_SETINFO took effect. This allows
* an application to reset the counters while atomically retrieving the
* last value.
*
* AUDIO_DRAIN suspends the calling process until the write buffers are
* empty.
*
* AUDIO_GETDEV returns a structure of type audio_device_t which contains
* three strings. The string "name" is a short identifying string (for
* example, the SBus Fcode name string), the string "version" identifies
* the current version of the device, and the "config" string identifies
* the specific configuration of the audio stream. All fields are
* device-dependent -- see the device specific manual pages for details.
*/
#define AUDIO_GETINFO _IOR('A', 1, audio_info_t)
#define AUDIO_SETINFO _IOWR('A', 2, audio_info_t)
#define AUDIO_DRAIN _IO('A', 3)
#define AUDIO_GETDEV _IOR('A', 4, audio_device_t)
/*
* The following ioctl sets the audio device into an internal loopback mode,
* if the hardware supports this. The argument is TRUE to set loopback,
* FALSE to reset to normal operation. If the hardware does not support
* internal loopback, the ioctl should fail with EINVAL.
*/
#define AUDIO_DIAG_LOOPBACK _IOW('A', 101, int)
/*
* Structure sent up as a M_PROTO message on trace streams
*/
struct audtrace_hdr {
uint_t seq; /* Sequence number (per-aud_stream) */
int type; /* device-dependent */
#if defined(_LP64) || defined(_I32LPx)
struct timeval32 timestamp;
#else
struct timeval timestamp;
#endif
char _f[8]; /* filler */
};
typedef struct audtrace_hdr audtrace_hdr_t;
#ifdef __cplusplus
}
#endif
#endif /* _SYS_AUDIOIO_H */
#endif