ref: 51f98101845fdfe52a9b3f5d05f143490fe8876e
dir: /openbsd-vmm.md/
Running 9front under OpenBSD VMM
================================
OpenBSD > 6.7 is required to run 9front. At the time of writing that
requires running `-current`.
Read the [FAQ entry](https://www.openbsd.org/faq/faq16.html),
especially the networking part.
Since VMM doesn't provide any display functionality, 9front's console
has to be redirected to virtual serial port by adding `console=0` to
`plan9.ini`. It makes sense to also use `display=none` while at it.
Note that even though you might not have a chance to modify
`plan9.ini` *before* booting, stopping boot process with an early hit
of a key, typing an additional configuration in, and then
`boot<ENTER>` is ought to work. Running `drawterm` is out of scope
here though.
Example of `/etc/vm.conf`:
vm "9front" {
disable # "enable" if you're brave
memory 2048M
disk "/path/to/9front.qcow2"
#cdrom "/path/to/9front.iso"
owner your_username_here
interface {
lladdr 52:54:00:00:EE:03
switch "uplink"
}
}
switch "uplink" {
interface bridge0
}
If connecting from outside of the host is required, perhaps a tweak of
`/etc/pf.conf` might help:
pass in on egress proto tcp from any to any port 564 rdr-to 10.0.2.2
pass in on egress proto tcp from any to any port 567 rdr-to 10.0.2.2
pass in on egress proto tcp from any to any port 17019 rdr-to 10.0.2.2
`10.0.2.2` is the IP address 9front VM gets, in this case, ie
`/etc/hostname.vether0` has `inet 10.0.2.1/24`.
Proper `/lib/ndb/local` is required.
## Notes
* to shut down the VM run `fshalt` *first*, then `vmctl stop 9front`