ref: a411870ee4640241e3c494367d922847da84f972
dir: purgatorio/os/js/mem.h
/* * Memory and machine-specific definitions. Used in C and assembler. */ /* * Sizes */ #define BI2BY 8 /* bits per byte */ #define BI2WD 32 /* bits per word */ #define BY2WD 4 /* bytes per word */ #define BY2V 8 /* bytes per double word */ #define BY2PG 4096 /* bytes per page */ #define WD2PG (BY2PG/BY2WD) /* words per page */ #define PGSHIFT 12 /* log(BY2PG) */ #define ROUND(s, sz) (((s)+(sz-1))&~(sz-1)) #define PGROUND(s) ROUND(s,BY2PG) #define MAXMACH 1 /* max # cpus system can run */ /* * Time */ #define HZ 50 /* clock frequency */ #define MS2HZ (1000/HZ) /* millisec per clock tick */ #define TK2SEC(t) ((t)/HZ) /* ticks to seconds */ #define MS2TK(t) ((((ulong)(t))*HZ)/1000) /* milliseconds to ticks */ /* * PSR bits */ #define PSREC 0x00002000 #define PSREF 0x00001000 #define PSRSUPER 0x00000080 #define PSRPSUPER 0x00000040 #define PSRET 0x00000020 #define SPL(n) (n<<8) /* * Magic registers */ #define MACH 6 /* R6 is m-> */ #define USER 5 /* R5 is u-> */ /* * Fundamental addresses */ #define USERADDR 0xE0000000 #define UREGADDR (USERADDR+BY2PG-((32+6)*BY2WD)) #define BOOTSTACK (KTZERO-0*BY2PG) #define TRAPS (KTZERO-2*BY2PG) /* * Reference MMU registers (ASI 4) */ #define PCR 0x000 #define CTPR 0x100 #define CXR 0x200 #define SFSR 0x300 #define SFAR 0x400 /* * Processor Control Register */ #define ITBRDISABLE (1<<16) #define BOOTMODE (1<<14) /* `must be cleared for normal operation' */ #define MEMPCHECK (1<<12) /* check parity */ #define ENABCACHE (3<<8) /* I & D caches */ #define NOFAULT (1<<1) /* no fault */ /* * special MMU regions * DMA segment for SBus DMA mapping via I/O MMU (hardware fixes location) * the frame buffer is mapped as one MMU region (16 Mbytes) * IO segments for device register pages etc. */ #define DMARANGE 0 #define DMASEGSIZE ((16*MB)<<DMARANGE) #define DMASEGBASE (0 - DMASEGSIZE) #define FBSEGSIZE (1*(16*MB)) /* multiples of 16*MB */ #define FBSEGBASE (DMASEGBASE - DMASEGSIZE) #define IOSEGSIZE (16*MB) #define IOSEGBASE (FBSEGBASE - IOSEGSIZE) /* * MMU entries */ #define PTPVALID 1 /* page table pointer */ #define PTEVALID 2 /* page table entry */ #define PTERONLY (2<<2) /* read/execute */ #define PTEWRITE (3<<2) /* read/write/execute */ #define PTEKERNEL (4<<2) /* execute only */ #define PTENOCACHE (0<<7) #define PTECACHE (1<<7) #define PTEACCESS (1<<5) #define PTEMODIFY (1<<6) #define PTEMAINMEM 0 #define PTEIO 0 #define PTEPROBEMEM (PTEVALID|PTEKERNEL|PTENOCACHE|PTEWRITE|PTEMAINMEM) #define PTEUNCACHED PTEACCESS /* use as software flag for putmmu */ #define NTLBPID 64 /* limited by microsparc hardware contexts */ #define PTEMAPMEM (1024*1024) #define PTEPERTAB (PTEMAPMEM/BY2PG) #define SEGMAPSIZE 128 #define INVALIDPTE 0 #define PPN(pa) (((ulong)(pa)>>4)&0x7FFFFF0) #define PPT(pn) ((ulong*)KADDR((((ulong)(pn)&~0xF)<<4))) /* * Virtual addresses */ #define VTAG(va) ((va>>22)&0x03F) #define VPN(va) ((va>>13)&0x1FF) /* * Address spaces */ #define KZERO 0xE0000000 /* base of kernel address space */ #define KTZERO (KZERO+4*BY2PG) /* first address in kernel text */ #define KSTACK 8192 /* size of kernel stack */ #define MACHSIZE 4096 /* * control registers in physical address space (ASI 20) */ #define IOCR 0x10000000 /* IO MMU control register */ #define IBAR 0x10000004 /* IO MMU page table base address */ #define AFR 0x10000018 /* address flush register */ #define AFSR 0x10001000 /* asynch fault status */ #define AFAR 0x10001004 /* asynch fault address */ #define SSCR(i) (0x10001010+(i)*4) /* Sbus slot i config register */ #define MFSR 0x10001020 /* memory fault status register */ #define MFAR 0x10001024 /* memory fault address register */ #define MID 0x10002000 /* sbus arbitration enable */ #define SYSCTL 0x71F00000 /* system control & reset register */ #define PROCINTCLR 0x71E00004 /* clear pending processor interrupts */ /* * IO MMU page table entry */ #define IOPTEVALID (1<<1) #define IOPTEWRITE (1<<2)