ref: 89e95268e95255fe126bd29fbf9bc3f658fefeb4
dir: /mnt-reform.md/
MNT Reform ========== See reform(1). See [sl's MNT reform page](http://plan9.stanleylieber.com/hardware/mnt/reform). Latest release: check for [*.reform.img.gz.torrent](http://9front.org/releases). This one boots from an SD card. ## Making 9front boot from EMMC, without an SD card *NO REFUNDS* First, make sure to run the latest (dated 2023-01-15, at least) kernel. The guide assumes you have NVME connected, in which case internal EMMC should be showing as `/dev/sdO0`, `/dev/sdO1` and `/dev/sdO2`. The first one is "user" range, where by default the Linux recovery partition is situated. The other two are "boot" partitions, where U-Boot resides (`/dev/sdO1` specifically). If NVME is *not* present, `sdO*` becomes `sdN*`. * install [ext4srv](https://git.sr.ht/~ft/ext4srv) * mount EMMC linux partition: `ext4srv && mount -c /srv/ext4 /n/emmc /dev/sdO0/linux` * copy `plan9.ini`, `9reform.u` and 9front's `/sys/src/boot/reform/boot.scr` to `/n/emmc/` * `unmount /n/emmc` * download U-Boot build with early screen enabled: `cd /sys/src/boot/reform; mk clean all` * update U-Boot: `dd -if /sys/src/boot/reform/flash.bin -of /dev/sdO1/data -bs 1024 -oseek 33 -trunc 0 -conv sync` * the switch under the heatsink should be positioned to booting from EMMC, this is not the default when the laptop is purchased Early boot may be interrupted with a key press. The current boot process is to try USB drives first, then an SD card, and finally boot from EMMC. If something went terribly wrong and you think the device is bricked, fear not! Change the heatsink boot switch into SD card boot mode and go from there.